Assembly; Installation - Husqvarna DMS 240 Manuel D'utilisation

Introduction
WARNING: Read and understand the safety
chapter before you assemble the product.
WARNING: To prevent injury, disconnect the
power cord and remove the drill bit before

assembly.

To attach the wheel kit
1. Attach the wheel kit on the rear side of the bottom
plate.
2. Tighten the screws.
Drill stand installation in operations
There are 2 methods that can be used to attach the drill
stand during a drill operation:
• With an expander bolt
• With a rod that has a thread, washer and locknut
898 - 002 - 20.06.2019
Assembly
To attach the drill motor
1. Lock the drill motor carriage.
2. Attach the drill motor on the installation plate (A).
3. Attach the installation plate and drill motor in the
track (B) on the drill motor carriage.
4. Turn the screw (C) to lock the drill motor into
position.

Installation

A
B
C
11