Table Des Matières; Introduction - Husqvarna DMS 240 Manuel D'utilisation

Introduction..................................................................... 2
Safety..............................................................................5
Assembly...................................................................... 11
Installation.....................................................................11
Operation...................................................................... 12
Maintenance................................................................. 14
Product description
The product is an electrical drill motor for concrete brick
and different stone materials. It is used with a drill stand.
Drill motor and drill stand
Drill stand
• The drill stand is used when you make holes in walls
and floors.
• The drill stand has an installation plate that makes
the drill motor easy to attach.
• The bottom plate is made of aluminum.
• The wheel kit can be removed.
• The drill column can be tilted 0-60°.
• The transmission of the feed lever housing is
adjustable. The higher position gives 2.5:1 and the
lower, 1:1.
• The feed lever is used to adjust the level screws of
the bottom plate and to set the applicable angle of
the drill column.
2
Contents
Troubleshooting............................................................ 16
Transportation and storage...........................................16
Technical data.............................................................. 17
Service..........................................................................18
EC Declaration of Conformity....................................... 19

Introduction

Drill motor
• The product has 2 gears.
• The product has double insulations.
• The product has an overload protection that
disconnects the power if the drill bit is blocked.
• The water system decreases the temperature of the
product.
898 - 002 - 20.06.2019