Mechanical Installation; Wall Mounting (Optional) - Hach Sigma 950 Manuel D'utilisation De Base

Mechanical installation

Do not use open screw holes on the rear of the instrument to hang additional equipment or instrument damage
can occur. The screw holes on the instrument can only hold the weight of the instrument.

Wall mounting (optional)

Attach the instrument to the optional wall mounting bracket, then install the instrument on a wall.
Refer to Figure 2.
Figure 2 Wall mounting
Suspension harness mounting (optional)
Attach the instrument to the optional suspension harness, then install the instrument in a manhole or
similar site.
1. Install the two captive ¼-20 mounting screws of the suspension harness in the two top holes on
the rear of the instrument.
2. Optional: Use the stainless steel clip on the top of the suspension harness to attach the optional
instrument support bracket for the suspension bracket or a similar support.
10 English
N O T I C E