Dolmar EV-3618 Manuel D'instructions Original page 8

For transportation and
+5mm
operation in autumn.
0mm
-5mm
-10mm lawn.
Changing the height
it to desired position.
Overload protection
This machine is equipped with overload protection, and it
•
materials are built up around it.
•
can handle.
•
When this protection works, the machine is switched off
automatically.
the machine.
OPERATION
•
operation.
•
•
also cause slip and fall.
• Do not move too fast. Push the machine slowly.
motor may overloaded.
•
•
even and smooth surface.
•
•
•
• Always take the weather into account. Warm, sunny
lawn can recover healthily. On the other hand, avoid
cold, heat, dry weather.
•
• If summer is wet, scarify the lawn in early autumn.
•
weather.
8
(Optional accessory)
For transportation and
operation.
operation.
• If summer is very dry, do not scarify in autumn.
• Plenty amount of air is needed for the area around the
•
lawn every 4 – 6 weeks in accordance with the state of
the lawn.
MAINTENANCE
CAUTION:
• Always be sure that the machine is switched off and un-
•
maintenance.
• The cutter does not stop immediately after switch off.
maintenance work.
• Make sure that all the tools are removed after mainte-
nance work.
•
result. To clean the machine, use only moist cloth and
soft brush.
•
water.
•
tool stops.
•
• Always transport the machine by its handle.
•
•
vehicles.
•
tool stops.
•
• Check, clean and store the machine in a dry room.
• Check all the clamps, such as screws, nuts etc. are
•
parts. Replace them if necessary.
•
deformed.
•
tion, that may be caused by unbalanced or deformed
service center if it happens.
•
•
-
-