Dometic PERFECTWALL PW3500 Notice D'utilisation page 19

PW3500
7.3 Resetting the motor and remote control
The motor and the remote control are adjusted to each other at the factory. Motor
and remote control must be reset in the following cases:
• If the awning does not respond to the remote control commands
• If the remote control or the receiver have been changed.
Step 1: Check the remote control battery
➤ Check whether the remote control battery is discharged or not:
Simply press a button on the remote control.
✓ The LED on the remote control lights up briefly.
If the LED does not light up, the battery is dead. Replace the battery, see chapter
"Changing the battery in the remote control" on page 14
Step 2: Check the motor and remote control
➤ Check whether the motor and remote control are working: Briefly press the
button.
✓ The awning extends all the way until it stops.
If the awning does not respond, does not extend all the way or stop after you
release the button, proceed with step 3.
EN
Adjusting the awning
19