Before You Start; Assembly - Shindaiwa EB770 Manuel D'utilisation

Before you start

Assembly

Read the operator's manual carefully to ensure that you assemble the product correctly.
Never perform maintenance or assembly procedures with engine running.
Using a product that has been incorrectly assembled could lead to an accident or serious injury.
Install blower pipes
1. Clamp with guide loop
3. Flexible pipe
5. Opening side
1. Handle
3. Swivel pipe
5. Anti-static wire
1. Throttle cable
3. Pinch
WARNING
2. Clamp
4. Swivel pipe
6. Around midway
2. Locking knob
4. Clamp
6. Elbow
2. Guide loop
4. Open
Before you start
1. Assemble clamp onto end with smaller diameter of flexible
pipe.
2. Assemble clamp with guide loop onto end with larger diam-
eter of flexible pipe. Place clamp with opening side of clip di-
rected upward.
NOTE
Clamp with cable guide loop fits elbow end of flexible pipe.
3. Assemble swivel pipe into flexible pipe and tighten clamp.
4. Insert anti-static wire through flexible pipe.
5. Assemble flexible pipe to elbow on blower. Place clamp with
guide loop around midway between end of flexible pipe and
bellows. Position guide loop on outside of flexible pipe (away
from blower) and tighten clamp.
6. Position cable along the outside of elbow. Loosen locking
knob on handle. AIign notch in handle with tabs. Install onto
swivel pipe past long ridges in pipe.
NOTE
A light lubricant may be used to ease assembly of flexible pipe
to blower elbow.
NOTE
Hang handle freely from blower to assure throttle cable is not
twisted before installing handle.
7. Clip throttle cable into guide loop.
8. Position handle for comfortable operation, and tighten lock-
ing knob hand tight.
9. Assemble straight pipe onto swivel pipe, until you feel light
resistance. Do not force connection. Hold swivel pipe and
turn straight pipe clockwise, engaging positive locking chan-
nels,until connection is firm. Do not force connection.
10. Assemble round straight nozzle or round bent nozzle to
straight pipe as in step 9.
14