Adjusting The Harness - Shindaiwa EB770 Manuel D'utilisation

1. Swivel pipe
3. Round straight nozzle

Adjusting the harness

1. Buckles
3. Adjust angle
2. Straight pipe
4. Round bent nozzle
2. Adjust position
Before you start
NOTE
Blower use will eventually loosen pipe connections. Exclusive
positive locking system allows pipes to be tightened. If loosen-
ing occurs, remove straight pipe and round straight nozzle or
straight pipe and round bent nozzle and install according to in-
structions 9 & 10.
1. Loosen upper and lower buckles, then put blower on your
back.
2. Pull strap downward to adjust position of blower.
3. Pull to adjust angle between your back and the blower.
15