Novy Essence 828/1 Mode D'emploi Et D'installation page 12

3. OPERATION
L = Lights
1 = Speed level 1
2 = Speed level 2
3 = Speed level 3
4 = Speed level 4
Switch on – switch off
Met toets 1 kunt u de motor inschakelen. Enkel met
deze toets is het mogelijk de motor te starten en te
stoppen.
Levels of intensity
The hood has 4 speed levels. With buttons 1 to 4 you
can choose the speed level. The illuminated buttons
shows the level in use
Illumination
You can switch on and off the illumination with button
"L"
Filter cleaning indicator
Fat filter: the 4 LEDs are flashing (see section
'Maintenance')
Carbon filter: the 4 LEDs are continuously lit (see
section 'Maintenance')
4. MAINTENANCE
Grease filter
After 30 cooking hours, the 4 LEDs will start
flashing when they are turned off. This indicates that
the grease filter needs cleaning.
Access to the grease filter
You can remove the filter by pulling the handle in the
filter (2).
Protect the cooking plate. You can take the grease filter
out of the hood by pulling the handle that has been
placed on the filter. The filter will come down.
Cleaning the filter:
• in the dishwasher
• manually: in a hot solution of water and a liquid
detergent. Rince and allow to dry completely
The previous instructions need to be followed. If
not an increased fire hazard may occur.
Carbon filter (only with recirculation)
After 120 cooking hours, the LEDs remain lit for
30 seconds when they are turned off. This indicates
that the carbon filter needs to be changed (if present). It
is recommended to clean the fat filter at the same time.
Access to the carbon filters
Remove the fat filters from the hood. The carbon filters
have been screwed at the left and the right sides on the
motor in the hood. Remove the carbon filter from the
motor with a turning and pulling movement.
Reset the timer
In order to reset the timer, press the button for position
4 of the motor and hold it for at least 3 seconds.
EN 12