Presettings; Changing Presettings With The Control Panel - ergoline Open Sun 550 A.R.T. Turbo Power Instructions De Service

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Changing presettings with the control panel

The setting mode enables you to call up operating states and make alte-
rations to current settings.
Changing to Presetting mode
– Press the buttons
and
seconds outside a tanning process.
appears in the display.
– Enter the code (see Page 74).
– Press the START/STOP button four times when you run the Preset-
ting mode for the first time.
briefly appears in the display, then
and the presetting value are displayed alternately (see column "On
delivery").
– By pressing the
button you scroll up to the next function (from
-01- to -19-).
– By pressing the
button you scroll down to the next function
(from -19- to -01-).
simultaneously for at least five
(Function 1)
Changing presettings
Increase the preset value:
– Press and hold the START/STOP button while simultaneously pres-
sing the
button.
Decrease the preset value:
– Press and hold the START/STOP button while simultaneously pres-
sing the
button.
Reset to the last value set:
– Press the START/STOP button.
Reset to the delivered state:
– See function
.
Note:
The sunbed will automatically return to 'idle' mode 30 seconds
after the last button was pressed.
The presettings are listed beginning on Page 76.
73

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Advantage 400 vhp 15

Table des Matières