Siebert SX202 Série Manuel D'utilisation page 36

Parameterization
The parameterization of the unit is done by means of a menu in the menu display.
During normal operation ON~ne appears in the menu display as soon as data arrive
at the serial interface.
To start the menu press both menu buttons simultaneously (approx. 1 sec.) until the
first menu item appears in the display. Now, you can navigate in the menu as follows:
Next menu item:
Page menu items forward:
Previous menu item:
Page menu items backward:
Next setting:
Page settings forward:
Previous setting:
Page setting backward:
Shortly press key [ ] in menu item U to quit the menu. Depending on the setting in
menu item U, the settings you made will be either saved (set), not saved (escape) or
the default settings will be restored with the exception of menu item 1 (default).
Canceling the menu without saving the settings made is possible by pressing both
menu buttons simultaneously (approx. 1 sec.) or will happen automatically if 60
seconds pass without a menu button being pressed.
Once the menu is closed or canceled, the unit behaves in the same manner as after
power-on.
In the menu mode the character
activated.
The menu is shown in the following menu table. Default settings are marked with *.
Individual menu items or settings may be suppressed in another menu item
depending on the type of unit or setting.
Menu item
1 Interface
36
Shortly press key [ ]
Press key [ ] long
Double click on key [ ]
Double click on [ ] and keep it pressed
Shortly press key [ ]
Press key [ ] long
Double click on key [ ]
Double click on key [ ] and keep it pressed
appears in the main display. The unit cannot be
Settings
RS232 (not for Modbus contril)
RS485
RS485 (4-wire bus)
RS485 (2-wire bus)
Menu display
1 232
1 485
1 485. 4
1 485. 2
BAL SX202 MDB M 1.0