Cleaning And Maintenance; Lubrication (Fig. G); Replacing The Batteries; Defects And Malfunctions - Tunturi R20 Rower Manuel De L'utilisateur

English
F1 Outstanding
F2 Excellent
F3 Good
F4 Fair
F5 Below average
F6 Poor
Trouble shooting:
- When the display of LCD is dim, it means the
batteries need to be changed.
- If there is no signal when you pedal, please
check if the cable is well connected.
NOTE
• When stop training for 4 minutes, the main
screen will be off.
• If the computer displays abnormally, please
re-install the batteries and try again.

Cleaning and maintenance

The equipment does not require special
maintenance. The equipment does not require
recalibration when it is assembled, used and
serviced according to the instructions.
WARNING
• Do not use solvents to clean the equipment.
• Clean the equipment with a soft, absorbent
cloth after each use.
• Regularly check that all screws and nuts
are tight.
• If necessary, lubricate the joints.

Lubrication (fig. G)

The equipment must be lubricated regularly, but
only if necessary.
- If necessary, apply a little lubricant as shown.

Replacing the batteries

The console is equipped with 2 AA batteries at the
rear of the console.
1. Remove the cover.
2. Remove the old batteries.
3. Insert the new batteries. Make sure that
batteries match the (+) and (-) polarity markings.
4. Mount the cover.

Defects and malfunctions

Despite continuous quality control, defects and
malfunctions caused by individual parts can occur
in the equipment. In most cases, it will be sufficient
to replace the defective part.
- If the equipment does not function properly,
immediately contact the dealer.
- Provide the model number and the serial
number of the equipment to the dealer. State
the nature of the problem, conditions of use
and purchase date.

Transport and storage

WARNING
• Carry and move the equipment with at least
two persons.
• Remain standing in front of the equipment
on each side and take a sturdy grip at the
handlebars. Tilt the front of the equipment
so as to lift the rear of the equipment on
the wheels. Move the equipment and
carefully put the equipment down. Place the
equipment on a protective base to prevent
damage to the floor surface.
• Move the equipment carefully over uneven
surfaces. Do not move the equipment
upstairs using the wheels, but carry the
equipment by the handlebars.
• Store the equipment in a dry place with as
little temperature variation as possible.

Additional information

Packaging disposal
Government guidelines ask that we reduce the
amount of waste material disposed of in land fill
sites. We therefore ask that you dispose of all
packaging waste responsibly at public recycling
centres.
2 4