Maintenance And Cleaning - S&P TURBO-351 N Manuel D'utilisation Et D'entretien

- Do not touch the device with wet or damp hands or feet, and do not pull on the power supply
cable.
- Before connecting the device to the electricity supply, ensure it is halted and that the grid voltage
corresponds to that shown on the data plate of the device.
- Disconnect the device when not in use or when carrying out cleaning work.
- Do not introduce any objects through the protection grille.
- Do not use this device if the protection grille is in a poor state or is incorrectly positioned.
OPERATION
- Once we have checked that the grid voltage corresponds with that shown on the device's data
plate and that the speed selector is in the halt position, connect the device to the grid.
- Select the speed at which we want the device to work, by rotating the speed selector (Fig. 1), in line
with the following values:
- Once the operation speed is selected, the device starts up automatically.
- The devices in the TURBO series have an adjustable head, which you can bend upwards or
downwards in line with your needs (Fig. 2).

MAINTENANCE AND CLEANING

- Ensure that the device is disconnected from the electrical grid before carrying out any
maintenance and/or operation work.
- Never use petrol or aggressive and/or abrasive dissolvents to clean the device, using instead a
cloth dampened with water.
- In order to access the blade of the device, remove the fixing ring from the front protection grille
(Fig.3), bearing in mind that a screwdriver is required to remove the safety screw.
- Once the cleaning operation is complete, remember to return the protection grille fixing ring using
the safety screw, in order to avoid accidents.
0 Halt
1 Slow speed
2 Medium speed
3 Quick speed
12