Prepare The Remote Transmitter; Operating Guide; Charge The Remote Transmitter - Petsafe PDT20-12471 Manuel D'utilisation

Step

Prepare the Remote Transmitter

1

Charge the Remote Transmitter

1. Lift the rubber cover protecting the Remote
Transmitter Charging Jack.
2. Connect one of the charger connectors to the
Remote Transmitter Charging Jack.
3. Plug the charger into a standard wall outlet. The
red light will appear.
4. Charge the Remote Transmitter for 24 hours for
the fi rst charge. Recharges take only 12 hours.
Note: The Transmitter Indicator Light is solid green
after 12 hours of charging. For the fi rst charge, continue
to charge the Remote Transmitter for an additional 12
hours.
5. When charging is completed, replace the rubber
cover.
Note: Approximate battery life between charges is 40 to 60 hours, depending on frequency of use.
Transmitter Indicator Light - Function and Response
Condition
Normal Operation
Normal Operation - Low Battery
Tone
Correction
Program Mode - Button Held
Program Mode - Button Released Flashes mode number
Charging
Charging Complete
6
400-1158-19.indd 6 400-1158-19.indd 6

Operating Guide

RED LED
OFF
Flashes 3 times every
5 seconds
OFF
ON length of Remote
Transmitter button
press
ON length of button
press
ON
OFF
www.petsafe.net
Charger connector placed
in the Remote Transmitter
Charging Jack
Dual Colour LED
GREEN LED
OFF
OFF
ON length of Remote
Transmitter button press
OFF
OFF
OFF
OFF
ON
9/25/09 10:41:04 AM 9/25/09 10:41:04 AM