Maytag Admiral AAV-1 Guide D'utilisation Et D'entretien page 11

Troubleshooting
Won't Fill
Won't Agitate
Won't Spin or Drain
Load is Wet
Stops
Leaks Water
Is Noisy
Fills with the Wrong
Temperature Water
Cycle Selector
Advances Through Off
• Plug cord into live electrical outlet.
• Check fuse or reset circuit breaker.
• Turn the control knob to proper cycle and pull knob out to start the washer.
• Turn both faucets on fully.
• Straighten inlet hoses.
• Disconnect hoses and clean screens. Hose filter screens may be plugged.
• Check fuse or reset circuit breaker.
• Make sure the lid is completely closed.
• Turn the control knob to proper cycle and pull knob out to start the washer.
• Pauses are normal. Wait and see if the washer will start again.
• Check fuse or reset circuit breaker.
• Straighten drain hoses. Eliminate kinked hoses. If there is a home drain restriction,
call for drain service.
• Close lid and pull knob out to start the washer. For your safety, washer will not spin
unless the lid is closed.
• Suds lock – caused by too much suds. Rewash without detergent. Use correct
amount of a low-sudsing detergent.
• Unevenly distributed load. Redistribute the load, close the lid and reset the control
dial for the final spin period. Check for leveling. Be sure water level is acceptable for
load size.
• A normal spin speed is recommended for heavy loads like jeans or towels.
• Plug cord into live electrical outlet.
• Check fuse or reset circuit breaker.
• Close lid and pull knob out to start the washer. For your safety, washer will not spin
unless lid is closed.
• This may be a pause in the cycle. Wait briefly and it may start.
• Make sure hose connections are tight.
• Make sure end of drain hose is correctly inserted and secured to drain facility.
• Avoid extended soaking – soak for 30 minutes or less.
• Avoid overloading.
• Be sure washer is leveled properly as outlined in installation manual.
• Weak floors can cause vibration and walking.
• Operating sounds will vary depending on agitation speed.
• Turn both faucets on fully.
• If equipped with a temperature selector knob, be sure it is set directly on a
temperature setting and not between settings.
• Make sure temperature selection is correct.
• Make sure hoses are connected to correct faucets and inlet connections. Be sure
water supply is regulated correctly. Flush water line before filling washer.
• Check the water heater. It should be set to deliver a minimum 120° F (49° C) hot
water at the tap. Also check water heater capacity and recovery rate.
• Disconnect hoses and clean screens. Hose filter screens may be plugged.
• Extra Rinse is selected. (select models)
10