HumanTechnik Signolux Guardion Interlink Mode D'emploi page 49

13. Registering the smoke detector with the receivers
The »signolux smoke detector« has to be registered with every
signolux-receiver in your system, which is later supposed to react to it.
EN
Registering the detector with a receiver allows the choice of indicati-
on on the according receiver. To register the detector with the relevant
receiver, press and hold that receiver's function key. The receiver's
event icons light up in sequence.
Release the function key as soon as the required alarm icon » « or
» « is lit.
The selected icon lights up for 7 seconds. While the icon is lit, press
the test button on the module inside the detector. The exterior test
button on the outside of the smoke detector can also be used.
Please note that this will trigger the detector's acoustic alarm.
Wait for approx. 20 seconds and the test the setup by pressing the test
button once again.
Up to 8 transmitters can be assigned to a single icon.
49