Causes And Termination Of False Alarms - HumanTechnik Signolux Guardion Interlink Mode D'emploi

11. Causes and termination of false alarms

The smoke detector can be triggered by steam, fine dust, condensation
and tobacco smoke. Small insects getting into the smoke alarm cham-
ber may also cause intermittent alarms.
Mount the smoke detector in areas unlikely to be affected by such
sources of false alarm. Refer to chapter 6 »Mounting place and project
planning samples«.
Stopping the alarm
In order to stop a current alarm, please proceed as follows:
- First identify the smoke detector which triggered the alarm. The test
button of the triggering smoke detector will flash red, the test buttons
of the triggered Interlink-smoke detectors do not.
- Remove the smoke detector which triggered the alarm from the base
and press the the test button of the RF module to stop the alarm. The
triggering smoke detector returns to its normal state and sends a stop-
ping signal to all Interlink smoke detectors, which in turn end their
alarm.
For your own safety, you should immediately and regardless check
your living space for small fires and sources of smoke.
EN
47