Changing The Batteries; Automatic Locking - Facom JET.7GM3EACC Notice Originale

Regular system operation
1. Hold a previously registered user card against the antenna.
2. The antenna sounds 1 beep and flashes in GREEN to open the
roller cabinet.
3. To close the roller cabinet, place the card against the antenna
again.
4. The antenna sounds 2 beeps and flashes in GREEN for closing.

4/ CHANGING THE BATTERIES:

CAUTION
ALWAYS REPLACE BATTERIES WITH IDENTICAL UNITS TO PREVENT RISKS
OF EXPLOSION.
USED BATTERIES MUST BE DISPOSED OF AS INSTRUCTED.
BATTERY TYPE - ALKALINE AA 1.5V x 4
An orange lamp flashes when the battery is low. Change the batteries.
To change the batteries, open the compartment cover with a hex key.
Remove the used batteries and install new ones.
Note: when changing the batteries, data remains stored in memory.
If you do not have spare batteries, you can still unlock the roller cabinet with the key.
Note: the label under the batteries indicates the lock's reference.

5/ AUTOMATIC LOCKING

By default, the unit locks automatically after 3 minutes opening (factory setting).
However, the E.ACCESS application allows this to be configured flexibly.
8