Problems And Solutions - tomado TMA9001W Mode D'emploi

First check the following before submitting the air conditioner for repair.
Problem
The appliance does not switch
on when pressing the on/off key.
The appliance does not cool
sufficiently.
The appliance makes a lot of noise.
The appliance does not switch
on for a period of 3 minutes
after it has been switched on.
Error code P1
Error code E0 EEPROM
Error code E1
Error code E2
Error code E3
Error code E4

PROBLEMS AND SOLUTIONS

Possible cause
The indicator light on the water tank
flashes and the water tank is full.
The room temperature is lower
than the set temperature.
Not all doors and windows are closed.
There are heat sources that are active
in the room.
The temperature is set too high.
The air inlet is blocked.
The surface on which the appliance
is placed is not level of flat enough.
The noise is caused by the flowing
refrigerant liquid within the air
conditioner.
The internal safety system of the
compressor prevents the appliance
from being switched on until 3 minutes
have passed since it was switched off.
The water tank is full.
Technical defect
Sensor for room temperature
defective.
Evaporator sensor defective.
Condenser sensor defective.
Operating panel defective.
EN - 32
Solution
Empty the water tank.
Set the temperature once more.
Make sure that all doors and windows
are closed.
Remove the heat sources or switch
them off if possible.
Set the temperature once more.
Clean the air inlet grille.
Place the appliance on a flat surface,
level if possible.
This is normal.
This delay is normal and the appliance
will function normally after
the 3 minutes have passed
Empty the water tank.
Contact the Inventum service
department.
Contact the Inventum service
department.
Contact the Inventum service
department.
Contact the Inventum service
department.
Contact the Inventum service
department.