Draining Condensation Water - tomado TMA9001W Mode D'emploi

LOCK BUTTON
To prevent the settings of the remote control from being changed, you can lock them with the lock button.
• Use a pointy object to activate the lock. A lock appears in the display on the remote control.
• It is no longer possible to control the appliance with the remote control.
• Press the lock button once more to deactivate the lock. The lock disappears and the appliance can be controlled again
by means of the remote control.
DISPLAY LIGHT
• If the display light on the appliance bothers you, you can switch it off by pressing the [led display] key.
Press the key once more to reactivate the display light.
AUTOMATIC RESTART AFTER POWER INTERRUPTION
After a power interruption, the appliance automatically restarts in accordance with the latest settings, once the power supply
has been restored.
CHANGING THE TEMPERATURE UNIT CELSIUS / FAHRENHEIT
Simultaneously hold down the + and - keys for 3 seconds to change the display of the temperature unit.
When the air conditioner is not used for a longer period of time, remove the rubber cap from the drain opening at the bottom
of the appliance and place an empty cup under the outlet.
All the water will flow out of the tank.
The water tank is equipped with an alarm sensor. When the water reaches a certain level in the water tank, the appliance
beeps 8 times and P1 appears in the display. The cooling process is switched off automatically. It is possible that the appliance
continues with air circulation.
Manual discharge - when using the appliance in a room with high air humidity.
1. Remove the plug from the socket.
2. Place a low receptacle under the lower outlet for condensation water discharge.
See the drawing.
3. Remove the screw cap.
4. The water flows out of the drain into the receptacle.
5. Place back the screw cap when no more water is flowing out.
6. Switch the appliance on again.
Continuous discharge - recommended when using the dehumidification position.
1. Remove the plug from the socket.
2. Remove the screw cap. Keep a drip tray at hand when removing the screw cap
in order to collect the condensation water that may come out of the outlet.
3. Connect the discharge hose (1/2" or 12.7 mm). See drawing.
4. The water is discharged continuously via the discharge hose.
5. Switch the appliance on again.
Condensation water can also be discharged as described on page 12, at section
DEHUMIDIFICATION.

DRAINING CONDENSATION WATER

EN - 30
drain opening
drain opening