tomado TMA9001W Mode D'emploi page 26

REMARK: Optimum operation of the air conditioner depends on the length of the discharge hose and the number
of bends. Try to limit both. The supplied flexible discharge hose has a maximum length of approx. 150 cm and corresponds
with the capacity of the air conditioner. The use of any other hoses or extensions could cause failures in the appliance.
The air should be able to flow without any hindrance, or else this could cause overheating of the appliance or condensation
of water in the air discharge hose. Therefore make sure there are no kinks or sharp bends in the discharge hose.
For an optimum result, the discharge hose should be kept shorter than 1 metre during use of the air conditioner.
INSTALLATION OF THE WINDOW SEAL SET
The window seal set is suitable for many windows. Installation of the window seal set is usually horizontal or vertical.
There is little difference between the methods of installation. It ensures that you are able to hang the discharge hose
to the outside, without hot air flowing into the room again or having problems with insects.
• Attach the supplied double-sided sealing tape on the window frame and the window in accordance with one
of the drawings below that is similar to your situation. Cut away excess tape.
• Then place the window seal set in the openings of the window.
• If necessary, attach the safety bracket with screws, so that it is impossible to open the window.
• Attach the connector to the end of the discharge hose on the window seal set.
Situation 1
sealing tape
Situation 2
sealing tape
window seal set
window seal set
EN - 26
bracket with
screws
bracket with
screws