Air Circulation; The Remote Control - tomado TMA9001W Mode D'emploi

DEHUMIDIFICATION
• Press the function key [mode] until the indicator light for dehumidification lights up on the display.
• The wind speed is automatically at low speed. This cannot be changed.
When using this position, a garden hose (not included in the delivery) or something similar must be connected to discharge
condensation water.
• Unscrew the screw cap on the back of the appliance.
• Mount the end of a garden hose or a similar discharge hose to the drain and place the other end in a receptacle situated
lower than the drain of the appliance, so that the condensate water can be discharged properly.
screw cap
Caution:
• Condensation water may run out of the drain when the screw cap is removed and the appliance has been used in cooling
mode. Keep a drip tray at hand when removing the screw cap, in order to collect the condensation water.
• Make sure the discharge hose for the condensation water properly descends and is not higher than the drain of the appliance.
• When using this position, the air discharge hose does not have to be connected.
• When using the cooling position, it is recommended to not discharge the condensation water continuously, but to close
the screw cap again. In this way the appliance is able to provide its best performance.

AIR CIRCULATION

When using this position, the air discharge hose does not have to be connected.
• Press the function key [mode] until the indicator light for air circulation lights up on the display.
• Press the [ fan speed ] key on the remote control to adjust the wind speed - low or high.

THE REMOTE CONTROL

garden hose
or discharge hose
Aim the remote control to the sensor of the appliance. The range of the remote control
isЇapprox. 8 metres (without obstacles between the appliance and the remote control).
Insert the two supplied AAA 1.5 Volt batteries in the remote control, as indicated in the drawing.
Do take the plus and minus symbols on the inside of the remote control into account.
Note:
• When the remote control is being replaced or will no
longer be used, remove the batteries and dispose them
in accordance with applicable legislation, as they are harmful
to the environment.
• Do not mix old and new batteries. Do not use a mix of alkaline,
standard (carbon-zinc) or chargeable (nickel-cadmium) batteries.
• Batteries could explode or leak when exposed to open fire.
Hand in batteries at a waste collection facility or recognised
waste collection point.
• Remove the batteries from the remote control when
the appliance is not being used for a longer period of time
(winter storage) and keep them on a cool, dry place.
EN - 28