Problems And Solutions; Technical Specifications - tomado TMA1201W Mode D'emploi

First check the following before submitting the air conditioner for repair.
Problem
The appliance does not switch on when pressing
the on/off key.
The appliance does not cool sufficiently.
The appliance makes a lot of noise.
Error code E0
Error code E1
Error code E2
Error code E3
Error code E4
Type number
Voltage
Connected load
Cooling capacity*
EE Class*
EER*
Power consumption kW
Power consumption Standby W
Current consumption nom. A
Air displacement max. m /h
3
Dehumidification max. ** L/h
Suitable for m
3
Refrigerant / GWP type/gr
Thermostat range °C
Fan speeds
Max. noise level dB(A)
Dimensions (hxwxd)
Nett weight
Protection class
Remote control
This symbol means that this product should not be disposed of with regular household waste (2012/19/EU). Observe the rules that apply in your country for the separated
collection of electric and electronic products. Correct disposal of the product prevents negative consequences for the environment and for public health. The packaging
material of this product can be recycled 100%, return packaging material separately.

PROBLEMS AND SOLUTIONS

Possible cause
The indicator light on the water tank flashes and the water tank
is full.
The room temperature is lower than the set temperature.
Not all doors and windows are closed.
There are heat sources active in the room.
The temperature is set too high.
The air inlet is blocked.
The surface on which the appliance is placed is not level of flat
enough.
The noise is caused by the flowing refrigerant liquid within the air
conditioner.
The sensor for room temperature is defective.
Condenser sensor defective.
The water tank is full.
Evaporator sensor defective.
The water tank is full.

TECHNICAL SPECIFICATIONS

TMA1201W
220-240Volt ~50Hz
1346 Watt
12000Btu/h (3.4kW)
A
2.6
1.3
0.5
5.9
380
1.2
105
R-290 / 3 /226 g.
16 - 31
2
65 dB(A)
715 x 440 x 335 mm
30.0 kg
IP20
yes
RECYCLING
EN - 23
Solution
Empty the water tank.
Set the temperature once more.
Make sure that all doors and windows are closed.
Remove the heat sources or switch them off if possible.
Set the temperature once more.
Clean the air inlet grille.
Place the appliance on a flat surface, level if possible.
This is normal.
Have the sensor replaced (the appliance is also able to function
without replacing the sensor).
Contact the Tomado service department.
Empty the water tank.
Contact the Tomado service department.
Empty the water tank.