Draining Condensation Water; Cleaning And Maintenance - tomado TMA1201W Mode D'emploi

DRAINING CONDENSATION WATER

When the air conditioner is not used for a longer period of time, remove the rubber cap from the drain opening at the bottom of the appliance and place an empty cup under the outlet.
All the water will flow out of the tank.
The water tank is equipped with an alarm sensor. When the water reaches a certain level in the water tank, the indicator light [ full ] lights up.
Should the water pump be defective, this could be an option for draining the water, as the water pump is not used in this way. The air conditioner will still be able to function properly.
When the water pump is defective, intermediate drainage can also be used. Keep an eye on the indicator light for full water tank [ full ], to see whether it lights.
Once the indicator led [ full ] lights, connect a discharge hose in the same way and all the water will flow out of the tank. In this way the air conditioner is also able to function properly.
Manual discharge - when using the appliance in a room with high air humidity.
1. Remove the plug from the socket.
2. Place a low receptacle under the lower outlet for condensation water discharge, see drawings 1, 2 and 3.
3. Remove the screw cap.
4. The water flows out of the drain into the receptacle.
5. Place back the screw cap when no more water is flowing out.
6. Switch the appliance on again.
2 3
1
Continuous discharge - recommended when using the dehumidification position.
1. Remove the plug from the socket.
2. Remove the screw cap. Keep a drip tray at hand when removing the screw cap in order to collect the condensation water that may come out of the outlet.
3. Connect the discharge hose (1/2" or 12.7 mm).
4. The water is discharged continuously via the discharge hose.
5. Switch the appliance on again.

CLEANING AND MAINTENANCE

Before cleaning the air conditioner, switch off the appliance by means of the ON/OFF key, wait a few minutes and remove the plug from the socket.
Cleaning the exterior
Clean the exterior of the appliance with a slightly damp cloth and then wipe it with a dry cloth.
If necessary, you can clean the exterior of the appliance by means of a mild washing-up liquid.
• Never wash the appliance with water. This can be dangerous.
• Do not use petrol, alcohol or similar solvents to clean the appliance.
• Never spray with insect sprays or similar agents.
• Do not use aggressive or abrasive cleaning agents for cleaning the appliance.
• Never submerge the appliance, cord or plug in water or any other liquid.
Cleaning the air filter
In order to allow the appliance to function as well as possible, we recommend cleaning the air filter every week.
The air filter could get clogged with dust and dirt. Remove the air filter as shown in the drawing.
Use a vacuum cleaner to remove all the dust from the air filter.
If the air filter is very dirty, you can clean it with lukewarm water.
• Submerge the air filter in lukewarm water (max. 40°C) containing a soft cleaning agent. Rinse the air filter a few times
and allow it to dry in the air. Do not place the air filter in the sun or on the heating to dry it.
• Place back the air filter. Check that it is fully dry, before using the appliance again.
Cleaning the air inlets
In order to allow the appliance to function as well as possible, you can clean the air inlets by means of a vacuum cleaner with a soft brush nozzle.
Start or end of the season
At the start of the season, check that the cord and plug are undamaged. Observe the installation instructions when placing the appliance.
At the end of the season, make sure there is no condensation water left in the appliance. Drain the water in accordance with the instructions in section DRAINING CONDENSATION WATER
and make sure the air filter is clean before storing the appliance.
EN - 22