Operation Of The Air Conditioner - tomado TMA1201W Mode D'emploi

page de 109

/ 109
Matières
Table des Matières
Signets

Table des Matières

Les langues disponibles

In addition to cooling, the air conditioner has two other functions, i.e. air circulation and dehumidification.

The air conditioner can be operated via the control panel on the appliance and with the provided remote control.

• Choose a location near a socket.

• Install the discharge hose in accordance with the figures and make sure the window is closed as much as possible.

• Insert the plug in an earthed socket.

• Press the on/off key

to switch on the air conditioner.

• The temperature range of the air conditioner is: 16 to 31°C.

• Check that the discharge hose is mounted correctly.

• Do not share the socket with any other appliances.

full

high

low timer

COOLING

• Press the mode key [mode] until the indicator light for cooling [ cool ] lights up on the display.

• Press the [ temp + / and temp - / ] keys to set the required room temperature (between 16°C and 31°C).

• Press the [ speed /

] key to set the wind speed.

DEHUMIDIFICATION

• Press the mode key [mode] until the indicator light for dehumidification [ dry ] lights up on the display.

• The air conditioner automatically adjusts the temperature to the current room temperature minus 2°C.

• The wind speed is at low speed automatically [ low ]. This cannot be changed.

When using this position, a garden hose (not included in the delivery) or something similar must be

connected to discharge condensation water.

• Unscrew the screw cap on the back of the appliance.

• Mount the end of a garden hose or a similar discharge hose to the drain and place the other end in

a receptacle, such as a bucket, situated lower than the drain of the appliance, so that the condensate

water can be discharged properly.

Caution:

• Condensation water may run out of the drain when the screw cap is removed and the appliance has been

used in cooling mode. Keep a drip tray at hand when removing the screw cap, in order to collect the

condensation water.

• Make sure the discharge hose for the condensation water properly descends and is not higher than the

drain of the appliance.

• When using this position, the air discharge hose does not have to be connected.

• When using the cooling position, it is recommended to not discharge the condensation water

continuously, but to close the screw cap again. In this way the appliance is able to provide its best

performance.

AIR CIRCULATION

When using this position, the air discharge hose does not have to be connected.

• Press the mode key [mode] until the indicator light for air circulation [ fan ] lights up on the display.

• Press the [ speed /

] key to adjust the wind speed - [low] or [high].

ADJUSTING THE TIMER

The timer function can be used to allow the air conditioner to switch on automatically (delayed start) or switch off automatically at a set time (automatic deactivation).

Delayed start

• Press the timer key [ timer/

] when the air conditioner is off and select the required time at which you want the air conditioner to switch on

by means of the [ temp + / en temp - / ] keys. The delayed start can be set between 0 and 24 hours.

• Confirm the number of hours by pressing the timer key [ timer/

• The set number of hours is shown in the display.

• When the set number of hours have passed, the air conditioner switches on automatically.

Automatic deactivation

• Press the timer key [ timer/

] when the air conditioner is on and select the required time at which you want the air conditioner to switch off using the

temperature and time [ temp + / and temp - / ] keys. Automatic deactivation can be set between 0 and 24 hours.

• Confirm the number of hours by pressing the timer key [ timer/

• The set number of hours is shown in the display.

• When the set number of hours have passed, the air conditioner switches off automatically.

THE REMOTE CONTROL

Aim the remote control to the sensor

Insert the two supplied AAA 1.5 Volt batteries in the remote control. Do take the plus and minus symbols on the inside of the remote control into account.

Note:

• If the remote control is replaced or is no longer used, remove the batteries and dispose them in accordance with applicable legislation, as they are harmful to the environment.

• Do not mix old and new batteries. Do not use a mix of alkaline, standard (carbon-zinc) or chargeable (nickel-cadmium) batteries.

• Batteries could explode or leak when exposed to open fire. Hand in batteries at a waste collection facility or recognised waste collection point.

• Remove the batteries from the remote control when the appliance is not being used for a longer period of time (winter storage) and keep them on a cool, dry place.