Zehnder ComfoAir 800 Guide D'installation Rapide page 13

� When hoisting, protect the housing from
denting by the hoisting strap. A suitable
load spreader can be used for this
purpose;
MAX.60°
� Remove the hoisting lugs after placing
the unit.
Checking the delivery
Contact your supplier immediately in case
of damage or an incomplete delivery. The
delivery should at least include:
� The unit; Check the identification plate
to ensure that it is the required type.
� Seal cap, seal plug, cable feed in
packaging;
� Hoisting instructions (attached to the
operating side);
� Documentation.
The unit can be supplied in the following
sizes:
ComfoAir 800
ComfoAir 1500
ComfoAir 2200
ComfoAir 3300
ComfoAir 4400
ComfoAir 6000
Meaning of the suffixes found on the
identification plate:
Suffix Explanation
ComfoAir XL Product family name
ComfoAir Eco
2200 Product type name (air
volumes in m 3 /h)
CFE The unit has a counterflow
plate exchanger installed as
default.
A The unit has a modulated frost
bypass installed in the outdoor
air as default.
L The unit is a left-hand version.
(Exhaust/Supply Left)
R The unit is a right-hand
version. (Exhaust/Supply
Right)
B The unit has an open/close
bypass installed as default.
BM The unit has a modulating
bypass installed as default.
I The unit is suitable for indoor
installation;
O The unit is suitable for outdoor
installation;
PF The unit has a panel filter
installed as default.
BF The unit has a bag filter
installed as default.
CL The unit has a cooler installed
as default.
PRH The unit has a pre heater
installed as default.
POH The unit has an postheater
installed as default.
DMP ODA The unit has an outdoor air
damper installed as default
DMP EHA The unit has an exhaust air
damper installed as default
The identification plate detailing
information on the unit can be found on
the operating side of the unit.
Suffixes between brackets mean
there is space reserved for
installing the specified function.
EN - 13