JB Systems Light STROBE MASTER BF-04A Mode D'emploi page 3

ENGLISH
4. NORMAL / FULL ON BUTTON: In normal mode you can choose any of the
internal programs. In "full on" mode all strobes will flash simultaneously, even when
the strobe master is in stand-by mode (see next)
5. RUN / STAND-BY BUTTON: In run mode the connected strobes follow the pattern
of the internal programs. In stand-by mode the outputs to the strobes are in
blackout mode (no output) and the related led is turned on.
6. MICRO: Internal microphone, used in sound mode. When the audio input on the
rear panel is used, the microphone is automatically switched off.
7. OUTPUT MONITOR: 4 leds monitor the output signals of the strobe master.
8. MIC SENSITIVITY: This potentiometer adjusts the input sensitivity of the audio
signal.
9. SPEED: In chase mode this potentiometer is used to adjust the running speed of
the selected program.
10. AUDIO INPUT: ¼" jack sound input, can be connected to an audio output (0,7V
2,5V) on your audio mixer. (for example a record output) When a jack connector is
inserted,the internal microphone is switched off.
11. OUTPUTS TO STROBES: four ¼" jack connectors used to connect the sync.
Inputs of compatible strobes. (see specs for strobe models that are compatible)
12. FUSEHOLDER: When the fuse is blown, only replace it with a similar 5x20mm
fuse, 1A slow.
13. MAINS CABLE: Mains input is rated at 220V / 50Hz.
JB SYSTEMS 3/16 STROBE MASTER BF-04A
OPERATION MANUAL