Operation - Medisana 40495 Mode D'emploi

GB

3 Operation

3 Operation
3.1
Insert/replace
batteries
3.2
Select the unit
of weight and
language
3.3
Weighing /
"Step-on" function
10
Before you start up your digital scale, insert the four provided 1,5V
batteries (type AAA) into the device. To do this, open the battery
4
compartment beneath the device and insert the batteries. Make
sure the polarity is correct (as shown in the battery compartment).
Put the lid of the battery compartment back on and push it until it
clicks into place. Change the batteries when the battery change
symbol "Lo" appears inthe display
the display after the device is switched on.
WARNING
• Do not disassemble batteries!
• Remove discharged batteries from the device immediately!
• Increased risk of leakage, avoid contact with skin, eyes and
mucous membranes! If battery acid comes in contact with
any of this parts, rinse the affected area with copious amoun-
ts of fresh water and seek medical attention immediately!
• If a battery has been swallowed seek medical attention
immediately!
• Replace all of the batteries simultaneously!
• Only replace with batteries of the same type, never use
different types of batteries together or used batteries with
new ones!
• Insert the batteries correctly, observing the polarity!
• Remove the batteries from the device if it is not going to be
used for an extended period!
• Keep batteries out of children's reach!
• Do not attempt to recharge these batteries! There is a
danger of explosion!
• Do not short circuit! There is a danger of explosion!
• Do not throw into a fire! There is a danger of explosion!
• Do not throw used batteries into the household refuse; put
them in a hazardous waste container or take them to a
battery collection point, at the shop where they were
purchased!
Shortly press your foot on the middle of the scale surface. "0.0"
appears in the display. You now may select the weight units (kg -
lb) with the sliding switch for setting the weight unit
shift key for setting the language
language for the audio output (German [DE] - Dutch [NL] -
French [FR] - Spanish [ES]). With the dial
the output volume at any time. If you do not do anything else, the
scale switches off after approx. 15 seconds automatically. It is now
ready for the "step-on" function.
1. Make sure the scale is placed on a firm, level surface. If you
want to weigh yourself but have moved the scale just before,
you must first initialise the scale. To do this, shortly press your
foot on the middle of the surface of the scale. "0.0" appears in
6
the display . After the scale switched off automatically, it is
ready for the "step-on" function. This procedure is not neces-
sary if you have not moved the scale.
6
or when nothing is shown in
BATTERY SAFETY INFORMATION
2
you may select the desired
E
3
. With the
1
you may adjust
G
G