Insert/Replace Batteries; Operation - Medisana PSL 40425 Mode D'emploi

3.1
Insert/replace
batteries
One button cell batterie (type CR2032) is already inserted in your new scale.
The insulating strip must be pulled out of the battery compartment
the underside of the unit before the scale can be operated. Replace the
batterie if the battery change symbol "Lo" appears in the display
nothing appears in the display when the device is switched on. To do this,
open the battery compartment beneath the device and insert one cell
batterie (type CR2032). Place the battery in the empty compartment (not the
compartment with the red sticker)! Please note polarity (positive pole
upwards; facing towards the lid). Close the battery compartment again.
WARNING
BATTERY SAFETY INFORMATION
• Do not disassemble batteries!
• Remove discharged batteries from the device immediately!
• Increased risk of leakage, avoid contact with skin, eyes and
mucous membranes! If battery acid comes in contact with
skin, rinse the affected area with copious amounts of fresh
water and seek medical attention immediately!
• If a battery has been swallowed seek medical attention
immediately!
• Replace all of the batteries simultaneously!
• Only replace with batteries of the same type, never use
different types of batteries together or used batteries with
new ones!
• Insert the batteries correctly, observing the polarity!
• Remove the batteries from the device if it is not going to be
used for an extended period!
• Keep batteries out of children's reach!
• Do not attempt to recharge these batteries! There is a danger
of explosion!
• Do not short circuit! There is a danger of explosion!
• Do not throw into a fire! There is a danger of explosion!
• Do not throw used batteries into the household refuse; put
them in a hazardous waste container or take them to a battery
collection point, at the shop where they were purchased!

3 Operation

on
or if
11
GB