Programming And Coffee Dosing Instructions; Water Dose Programming Instructions; Special Push-Button Panel Functions - Model "Desiderio; Special Push-Button Panel Functions - Model "Geniale - La Pavoni DESIDERIO V Manuel D'utilisation

9. PROGRAMMING AND COFFEE DOSING
INSTRUCTIONS (DESIDERIO AND GENIALE
"V" MODELS) (Fig. 2)
Button function:
6. 1 normal coffee
16. 2 normal coffees
18. 1 long coffee
26. 2 long coffees
17. Stop group head controls / continuous
delivery.
The button (17) is used for continuous delivery
and to stop delivery.
Therefore the machine has a double function:
• A. Pressing button (17) will make the machine
operate in semi-automatic mode.
• B. Pressing the 4 selection buttons will make the
machine operate in electronic volumetric dosing
mode.
Pressing and holding the button (17) for 5 seconds
will make the machine switch to programming
mode, which will be indicated by the slow flashing
of the LED.
Release the programming button (the LED will
continue to flash); within 30 seconds press the
button of the group head on which you wish to
program coffee dosing. Once the required dose
has been reached, press any button of the same
group head to stop delivery. The dose will be
stored in the memory and the machine will exit
from programming mode (the flashing LED will
switch off).
1. This should be repeated for the remaining
selection buttons of the various group heads.
2. Repeat the same procedure if you wish to
increase or decrease the set dose.
3. Programming the first group head on the left
will copy the settings onto the other group heads.
This does not prevent you from using procedure
described above to program the remaining group
heads independently from the first one.
9–1. WATER DOSE PROGRAMMING
INSTRUCTIONS
Pressing and holding the button (17) for 5 seconds
will make the machine switch to programming
mode; release the programming button (the
LED will continue to flash). Press the hot water
dispensing button (15) within 30 seconds; hot
water will start to be dispensed from the tap
(13); once the required dose has been reached,
press the hot water delivery button to stop the
water. The LED will switch off, the dose will be
stored in memory and the machine will exit from
programming mode.
9–2. SPECIAL PUSH-BUTTON PANEL FUNCTIONS
- MODEL "DESIDERIO"
A. Machine switching off
When the machine is on, you can switch to IDLE-
OFF mode by pressing and holding the button (17)
and then the button (18) immediately afterwards.
Press the button (18) to switch the machine on
again.
The following combination works on the
control panel for the first group head.
B. Switching the heating for individual group
heads on and off
The heating of the individual group heads can
be switched off by pressing and holding the
button (17) and then the button (16) immediately
afterwards.
To switch the heating on again, press the button
(17) and then the button (16) immediately
afterwards.
C. Washing
A wash cycle can be activated for each group head
by pressing and holding the button (17) and then
the button (6) immediately afterwards.
The solenoid valve and the pump of the selected
group head will function for 5 consecutive delivery
cycles of approximately 10 seconds each; with a
3-second pause between cycles.
9–3. SPECIAL PUSH-BUTTON PANEL FUNCTIONS
- MODEL "GENIALE V"
Carry out the settings from group head 1 push-
button panel.
1. Machine switching off
When the machine is on, you can switch to IDLE-
OFF mode by pressing and holding the button (17)
and then the button (18) immediately afterwards.
Press the button (18) to switch the machine on
again.
The following combination works on the
control panel for the first group head.
2. Washing
A wash cycle can be activated for each group head
by pressing and holding the button (17) and then
the button (6) immediately afterwards.
The solenoid valve and the pump of the selected
group head will function for 5 consecutive delivery
25