5 Solving problems
5.1 Correcting problems yourself
Before contacting the service hotline (Zpage 123, „International Service"), please check if you can solve the prob-
lem yourself using the following table.
WARNING:
Never use a faulty appliance or operate an appliance with a faulty power cord.
Before you try to localise the problem, switch off the appliance and pull the plug from the socket.
Problem
The appliance will
The power cord is not plugged in. Insert the plug into the plug socket.
not start
Battery for the remote control
too low or flat.
The cover panel is not fitted or is
not fitted correctly.
®
Truman Cell
Truman Cell
cleaning indicator
("
") lights up
®
The Truman Cell
Truman Cell
cleaning indicator
cleaning or due to high air hu-
("
") flashes
midity.
quickly
The appliance has been switched
off as a result of a short circuit or
due to electrical flashover.
®
The Truman Cell
The appliance is in drying mode,
see Zchapter 4.3, „Drying the
cleaning indicator
("
") flashes
wet Truman Cell® (drying mode)".
slowly
Possible cause
®
need to be cleaned. Clean the Truman Cell
®
is too wet after
Solution
Replace the battery, Zchapter 5.4, „Changing the re-
mote control's battery".
Fit the cover panel (again). To do so, first insert it at the
bottom and then push it firmly at the top. Make sure
that you hear and feel it click into place.
as described in Zchapter 4.2,
®
„Cleaning the filter components".
®
Dry the Truman Cell
in the appliance as described in
Zchapter 4.3, „Drying the wet Truman Cell® (drying
mode)".
Remove and clean the Truman Cell
®
Re-insert the Truman Cell
®
If the Truman Cell
cleaning indicator ("
flashes quickly again but it can be connected at the
same time, meaning the Truman Cell
been too wet, it will need to be cleaned by the Customer
Service department (Zchapter 5.2, „Hotline and cus-
tomer service"). Return it for this purpose.
See Zchapter 4.3, „Drying the wet Truman Cell® (drying
mode)".
®
.
.
") then
®
may just have
35