Drying The Wet Truman Cell® (Drying Mode) - Oreck DualMax AC2000 Mode D'emploi

4.3 Drying the wet Truman Cell
As soon as the appliance controller detects that the Truman Cell
®
Truman Cell . The Truman Cell
16
TRUMAN CELL
60 min
TRUMAN CELL
NOTE:
If, at the end of the 3rd drying cycle, the appliance controller still cannot establish the power supply, the appli-
ance switches to normal mode with a normal speed nevertheless. However, the Truman Cell
(" ") then continually flashes quickly. The Truman Cell
is still causing short circuits. However, it is also possible that the Truman Cell
replaced.
34
®
cleaning indicator ("
1. Press the and hold the
- The LEDs for the
times.
- The appliance reduces its speed.
- The Truman Cell
slowly.
- The appliance now runs in drying mode for approximately 60
minutes. At the end of this period of approximately 60 min-
utes, the appliance controller attempts to restore the power
supply to the Truman Cell
- If the Truman Cell
switches to normal mode with a normal speed and the Tru-
man Cell
- If the Truman Cell
gins. This cycle runs up to 3 times.
®
(drying mode)
®
is still wet, it switches off the power supply to the
") flashes quickly (Fig. 16).
button on the appliance.
button on the appliance light up 3
®
cleaning indicator ("
®
®
is now sufficiently dry, the appliance
®
cleaning indicator ("
®
is still too wet, a new drying mode be-
®
will then probably have to be cleaned again as soiling
®
") now flashes
.
") goes out.
®
cleaning indicator
is damaged and will need to be