Electric Safety; Machine Usage; Setup On An Uneven Surface - Titan POWRMAX 605 Mode D'emploi

SAFETY PRECAUTIONS
1.2

ELECTRIC SAFETY

Electric models must be grounded (earthed). In the event of
an electrical short circuit, grounding (earthing) reduces the risk
of electric shock by providing an escape wire for the electric
current. This product is equipped with a cord having an
earthing wire with an appropriate earthing plug. Connection to
the mains only through a special feed point, e.g. through an
error protection insallation with INF < 30 mA.
DANGER — Work or repairs at the electrical
equipment may only be carried out by a skilled
electrician. No liability is assumed for incorrect
installation. Switch the unit off. Before all repair
work, unplug the power plug from the outlet.
Danger of short-circuits caused by water
ingressing into the electrical equipment. Never
spray down the unit with high-pressure or high-
pressure steam cleaners.
Whenever the machine is automatically brought
to a standstill or during power failure, immediately
move the selector switch to "A" to prevent the
machine starting back up again unintentionally.
There is a danger of injury.
1.3

MACHINE USAGE

The mortar spraying machine PowrMax 605 may only be used
to process the coating materials described on page 7. Any
other usage is not allowed.
Proper usage also includes the observance of the operating
manual and the observance of the inspection and maintenance
conditions. Always keep the operating manual on hand at the
point of use of the mortar spraying machine.
The mortar spraying machine PowrMax 605 may only be
operated with a manometer. Only the mortar hose specified by
the manufacturer may be used.
Use only marked mortar hoses with at least 40 bars operating
pressure.
The mortar spraying machine is intended exclusively for
commercial use by professionals.
6
1.4

SETUP ON AN UNEVEN SURFACE

The mortar spraying machine must be installed as shown in the
diagram below to prevent it slipping. Block front wheels with
brakes.
PowrMax