Fitting The Glass Panel; Mounting The Front Panel Concerto; Mounting The Front Panel Vision; Remote Control - Dru CONCERTO CF Instructions D'installation Et Mode D'emploi

You can "play" with the flames by moving the vermiculite,
embers and chips about on the burner bed until you have
created the desired flame effect.
Do not use any materials other than those supplied.The
supplied materials are incombustible and have been
manufactured specifically for this appliance.

Fitting the glass panel

Once the logs are in place, the glass can be replaced in the
brackets nges and tightened with the two socket-head
bolts. In the event of damage or breakage, the glass should
be replaced immediately.
Mounting the front panel Concerto (fig. 9a)
The coloured or stainless steel frame (A) is packed
separately from the basic set.The frame is fitted to the
front panel (B) using the 8 bolts supplied (C). Make sure
that the tall edge is at the bottom.
Mounting the front panel Concerto Vision
(fig. 9b)
The front panel is packed separately to the basic set, and
fitted as follows.
Remove the magnets to the basic set.
Fix the mounting frame (A) to the base set with the sheet
metal screws (B).
Now hang the front frame (C) onto the mounting frame.
INSTRUCTIONS FOR INSTALLATION
fig. 5
For safety reasons a guard should be placed in
front of the fire at all times.

Remote control

Remote control is supplied as a standard accessory.
The heater has a freely adjustable. Batteries, with a life
expectancy of approximately one year, feed the electrical
supply.The remote control will only work if the pilot light
is lit.
17
Tall edge
fig. 9a
Concerto CF