Connecting To The Gas Supply; Positioning The Logs - Dru CONCERTO CF Instructions D'installation Et Mode D'emploi

INSTRUCTIONS FOR INSTALLATION

Connecting to the gas supply

The gas control block has a 3/8" internal thread for the
gas connection.
Use an approved connecting tap with coupling in the
supply pipe (for Belgium this must be B.G.V. approved).
In addition:
• Expel the air from the supply pipes before connecting the
appliance.
• Avoid pressure on the gas control block and the pipes.
• Check all connections for gas tightness.

Positioning the logs

Special vermiculite and chips have been developed for the
Concerto Vision to create a decorative black appearance.
You have the option of using either the vermiculite, chips
and from the log set, or the black accessory set
with black vermiculite and chips especially designed for the
Concerto Vision.
NB: Do not use both!
• Lay the large log against the back wall.
• When you use the vermiculite, chips from the log set:
• Fill the burner with vermiculite.
• Spread it evenly over the burner tray.
step 1
step 2
• Sprinkle the chips(black and yellow) evenly on the burner
and surrounding tray.
• Make sure that no vermiculite/chips gets on or into the
pilot light burner, as this could prevent it from working
properly.
• It is important to first sprinkle the vermiculite on the
burner tray and then the chips, as this will give the best
flame effect.
When you use the black accessory set:
• Fill the burner with vermiculite.
• Spread it evenly over the burner tray.
• Sprinkle the black chips on the top of the vermiculiet on
the burner an the surrounding tray.
• It is important to first sprinkle the vermiculite on the
burner tray and then the chips, as this will give the best
flame effect.
• Make sure that no vermiculite/chips gets on or into the
pilot light burner, as this could prevent it from working
properly.
• Now lay the rest of the logs in place as illustrated in fig. 5.
The logs should not be laid in any other way as this could
cause the formation of soot. Neither should the logs touch
pilot light burner.
16
step 3
step 4