Maintenance; Cleaning And Care - Argo X2 Série Notice D'utilisation Et D'installation

MAINTENANCE

ATTENTION
- Switch off the unit and remove the
power supply before performing any
maintenance interventions.
CLEANING THE AIR FILTERS (EVERY THREE WEEKS)
In dusty rooms it ma y be necessary to
clean the air filters more frequently.

CLEANING AND CARE

REMOVING THE FILTERS
- Lift the front panel of the indoor unit as
shown in figure (a).
CLEANING THE FILTERS
- Clean the fi lters with a suction device.
CONTROLS BEFORE USE
- Make sure nothing is obstructing the
air intake or discharge of the indoor or
outdoor units.
- Make sure the unit is earthed correctly
- Make sure the fi lters are clean and if
MAINTENANCE AFTER USE
- Remove the electric po wer supply after
use.
- Do not spray or throw water on to the
unit. This could cause electric shocks or
damage the unit.
Attention after remo ving the fi lters, avoid
contact with the grilled heat exc
(risk of cuts or abrasions).
- Remo ve the fi lters b y lifting one of the
bottom corners as shown in figure (b).
(a)
- Make sure the fi
condition. If damaged, replace them.
damaged, replace them.
- P eriodically c heck that the br ackets
supporting the outdoor unit are integral.
- Clean the filters, the indoor unit and the
outdoor unit.
- Do not use hot water, thinners, abrasive
powder or strong solvents to clean the
unit.
hanger
- Remove the filters by pulling towards the
bottom as shown in figure (c).
(b)
lters are in good - Replace the fi lters in their seats
- Close the front panel
(c)
28