Remote Control Functions; Light Button; Turbo Button - Argo X2 Série Notice D'utilisation Et D'installation

REMOTE CONTROL FUNCTIONS

REMOTE CONTROL
BLOW
BLOW or X-FAN BUTTON
The BLO W progr am allo ws the remo val
of an y condensation on the indoor unit'
heat exc hanger w hen pressing OFF in the
Cooling and Dehumidi
modes. Activating this progr am, the icon
is displayed on the remote control. At switch
of the unit is on stand-b y and the v entilation
functions at a minimum speed with the
horizontal discharge grills open for a further
10 minutes. To interrupt the BLO W program,
press the BLOW button again: ventilation will
stop and the discharge grills will close.
TURBO

TURBO BUTTON

Press this button to acti vate or deacti v ate Turbo
ventilation. This speed is available in Cooling
and Heating function modes.
the Turbo v entilation, the follo wing icon
will be displa yed on the remote control. The
Turbo fan speed can be deacti vated even by
changing the function mode or the ventilation
speed by means of the FAN button.
s
cation function
After setting
+
+ BUTTON
Press this button to increase the temper ature
set.
Pressing this button will increase the
temperature by 1°C from a minimum of 16°C
to a maximum of 30°C
It is not possible to set the temper
AUTO function mode..
-
- BUTTON
Press this button to decrease the temper ature
set.
Pressing this button will decrease the
temperature by 1°C from a minimum of 16°C
to a maximum of 30°C
It is not possible to set the temper
AUTO function mode
LIGHT

LIGHT BUTTON

Press this button to acti vate or deactivate the
display on the panel of the indoor unit.
ature in
ature in
24