Burg Wächter SECUTRONIC Mode D'emploi page 6

Figure
Clear button
Quitting the programming mode
On / Enter button
Readiness for opening
LED goes on when a valid opening code is entered and programming
is successful.
Battery replacement symbol
When this LED is on, please replace all 3 batteries
(LR6 / AA / 1.5V / Alkaline).
Readiness for entry / programming
The LED goes on when the programming mode is entered. It goes off when
the programming mode is exited again.
Rejected entry / blocking time
The LED goes on when an invalid code is entered or when the programming
is incorrect. In case a wrong code is entered three times in a row, the lock
is blocked for 5 minutes. During this time, the LED flashes. In this status,
opening is not possible, even with a correct opening code.
Dear customer,
Thank you for deciding for a safe with the BURG-WÄCHTER SECUTRONIC
electronics. This electronics is certified according to ECB•S class A and opening
is possible by using a Pincode. You have thus acquired a product meeting
extremely high security requirements and developed and manufactured using
the latest technical potential.
Important: Please read the entire User Manual before programming
and store this User Manual at a safe place for future reference at any time
you may need it.
We hope you will enjoy your BURG-WÄCHTER safe.
Your BURG-WÄCHTER KG
Important information about our electronic locks
General information: Please take care that the codes and the code carrier
do not fall into the wrong hands. Therefore, store the codes and code
carrier at a safe location so that these can only be accessed by authorised
persons. In case you loose a code or code carrier, the lock must be
converted to a new code/code carrier, or replaced.
– The factory code must be changed as soon as the lock is commissioned.
– Simple codes that are easy to guess (e. g. 1, 2, 3, 4, 5, 6) must not be used.
– Personal data (e. g. birthday) or other data that may be concluded with
knowledge of the code owner must not be used as code.
– Any changes of the administrator code and of the user codes shall be made
with the safe door opened! When the locking system has been reset to
another code, this new code should be repeatedly used with the safe door
opened.
8 I English SECUTRONIC