WMF MASTER Manuel D'instructions page 10

6.6| SOUND SETTINGS
Press the setting button (12) on the touch
screen. The level of sound volume set will
appear on the LED display (by default L3). Turn
the rotary knob (5) to set the volume higher or
lower and press the rotary knob to confirm.
6.7| CUSTOMIZATION OF FUNCTIONS
The times of both the warming/retoasting (8)
and the defrost (11) functions are customizable.
In order to change it, press the setting but-
ton (12) on the touch screen, then the function
you desire to change. The LED display (3) will
show the default value. Change it by turning
the rotary knob (5) and press the rotary knob to
confirm.
6.8| CRUMB TRAY
Crumbs produced during toasting are collected
in the crumb tray (6). To empty, briefly press
against the crumb tray. You will then be able to
pull it out of the device.
7| CLEANING AND CARE
Before cleaning, disconnect the appliance from
the mains and allow the appliance to cool
down. Use a hard brush to remove crumbs stick-
ing to the grids and the heater. Do not tilt the
appliance while you do this, or crumbs will
spill from the crumb tray into the inside of the
toaster. Then pull out the crumb tray, clean it
and reinsert.
Never immerse the toaster in water. Wipe the
outside of the appliance only with a damp cloth
and some washing-up liquid. Do not use harsh
or abrasive cleaning agents. Do not clean with
oven/grill spray. Do not use a steam cleaner.
18
8| TECHNICAL DATA
Voltage: 220–240 V~ 50–60 Hz
Power consumption: 820–980 W
Appliance class: I
Technical information on the operating modes pursuant to EU Regulation 2023/826:
MODE POWER CONSUMPTION (WATT)
OFF
Standby
Standby with additional
information
Networked standby
The appliance complies with European directives 2014/35/EU, 2014/30/EU and 2009/125/EU.
For UK use only
▪ This product is supplied with a 13 A plug con-
forming to BS 1363 fitted to the mains lead. If
the plug is unsuitable for your socket outlets or
needs to be replaced, please note the following.
If the plug is a non-rewireable one, cut it from
the mains lead and immediately dispose of it.
Never insert it into a socket outlet as there is a
very great risk of an electric shock.
▪ The replacement of the plug at the mains lead
has to be done according to the following
instructions:
Warning - This appliance must be earthed
Important: The wires in this mains lead are
coloured in accordance with the following
code:
green/yellow Earth
blue Neutral
brown Live
As the colours of the wires in the mains lead
of this appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
⋅
the wire which is coloured green and
yellow must be connected to the terminal
which is marked with the letter E or by
the earth symbol , or coloured green or
green and yellow,
⋅
the wire which is coloured blue must
be connected to the terminal which is
marked the letter N or coloured black,
⋅ the wire which is coloured brown must
be connected to the terminal which is
marked with the letter L or coloured red.
PERIOD (MINUTES)
0.3 3
– –
– –
– –
▪ If a 13 A (BS 1363) plug is used it must be
fitted with a 13 A fuse conforming to BS 1362
and be ASTA approved. If any other type of
plug is used, the appliance must be protected
by a 10 A fuse either in the plug or adapter or
at the distribution board.
If in doubt - consult a qualified electrician.
▪ Never use the plug without closing the fuse
cover.
Environment
Environment protection first!
Your appliance contains valuable materials
which can be recovered or recycled.
Leave it at a local civic waste
collection point.
Changes possible.
19