Assembly - Husqvarna 540i XP Manuel D'utilisation

saw chain and chain drive sprocket. Refer to
adjust the tension of the saw chain on page 31 .
• Do maintenance on the cutting equipment regularly
and keep it correctly lubricated. If the saw chain is
not correctly lubricated, the risk of wear on the
To assemble the guide bar and saw
chain
WARNING:
before you assemble or do maintenance on
the product.
1. Disengage the chain brake.
2. Loosen the bar nut and remove the drive sprocket
cover and the transportation ring (A).
3. Put the guide bar on top of the bar bolt. Steer the
guide bar to its most rear position. Lift the saw
chain above the drive sprocket and engage it in the
groove on the guide bar. Start on the top edge of
the guide bar.
14
To

Assembly

Always remove the battery
A
guide bar, saw chain and chain drive sprocket
increases.
4. Make sure that the edges of the cutters point
forward on the top edge of the guide bar.
5. Install the drive sprocket cover and steer the chain
adjuster pin to the hole in the guide bar.
6. Make sure that the drive links of the saw chain fit
correctly on the drive sprocket.
7. Make sure that the saw chain is correctly engaged
in the groove in the guide bar.
8. Tighten the bar nut with your fingers.
9. Tighten the saw chain. Refer to
tension of the saw chain on page 31 for
instructions.
To assemble a spiked bumper
To assemble a spiked bumper, speak to your servicing
dealer.
To install the air intake cover
If you cut materials that cause much dust and small
particles in the air, a air intake cover is recommended
for use.
1. Hold the air intake cover against the fan housing.
Make sure to put the hole in the air intake cover on
the right side of the hole in the fan housing.
To adjust the
1065 - 005 - 29.06.2020