Battery Charger Safety; Safety Instructions For Maintenance - Husqvarna 540i XP Manuel D'utilisation

Battery charger safety

WARNING:
instructions that follow before you use the
product.
• Risk of electrical shock or short circuit if the safety
instructions are not obeyed.
• Use an approved grounded mains socket that is
not damaged.
• Do not use other battery chargers than the one
supplied for your product. Only use Husqvarna QC
chargers when you charge Husqvarna replacement
batteries BLi.
• Do not try to disassemble the battery charger.
• Do not use a defective or damaged battery
charger.
• Do not lift the battery charger by the power cord.
To disconnect the battery charger from a mains
socket, pull out the plug. Do not pull the power
cord.
• Keep all cables and extension leads away from
water, oil and sharp edges. Make sure that the
cable is not caught between doors, fences or
similar.
• Do not use the battery charger near flammable
materials or materials that can cause corrosion.
Make sure that the battery charger is not covered.
Pull out the plug to the battery charger if there is
smoke or fire.
• Only charge the battery indoors in a location with
good airflow and away from sunlight. Do not charge
the battery outdoors. Do not charge the battery in
wet conditions.
• Only use the battery charger where the
temperature is between 5 °C (41 °F) and 40 °C
(104 °F). Use the charger in an environment which
has a good airflow, dry and free from dust.
• Do not put objects into the cooling slots of the
battery charger.
• Do not connect the battery charger terminals to
metal objects as this can short circuit the battery
charger.
• Use approved wall sockets that are not damaged.
• Use only three-wire outdoor extension cords that
have three-prong grounding plugs and grounding
receptacles that accept the appliance's plug.

Safety instructions for maintenance

WARNING:
instructions that follow before you do
maintenance on the product.
• Remove the battery before you do maintenance,
other checks or assemble the product.
1065 - 005 - 29.06.2020
Read the warning
Read the warning
• The operator must only do the maintenance and
servicing shown in this operator's manual. Turn to
your servicing dealer for maintenance and
servicing of a larger extension.
• Do not clean the battery or the battery charger with
water. Strong detergent can cause damage to the
plastic.
• If you do not do maintenance, it decreases the life
cycle of the product and increases the risk of
accidents.
• Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual
are approved after you have done maintenance,
turn to your servicing dealer. We guarantee that
there are professional repairs and servicing
available for your product.
• Only use original spare parts.
Safety instructions for the cutting equipment
WARNING:
instructions that follow before you use the
product.
• Only use approved guide bar/saw chain
combinations and filing equipment. Refer to
Technical data on page 36 for instructions.
• Use protective gloves when you use or do
maintenance on the saw chain. A saw chain that
does not move can also cause injuries.
• Keep the cutting teeth correctly sharpened. Obey
the instructions and use the recommended file
gauge. A saw chain that is damaged or incorrectly
sharpened increases the risk of accidents.
• Keep the correct depth gauge setting. Obey the
instructions and use the recommended depth
gauge setting. Too large depth gauge setting
increases the risk of kickback.
• Make sure that the saw chain has the correct
tension. If the saw chain is not tight against the
guide bar, the saw chain can derail. An incorrect
saw chain tension increases wear on the guide bar,
Read the warning
13