Festool DUPLEX LS 130 EQ Notice D'utilisation D'origine page 7

Stirrer
Technical data
Power
Speed (no load):
Working strokes
Sanding stroke
Sanding shoe
Weight according to
EPTA-Procedure 01:2014
The specifi ed illustrations can be found at the be-
ginning of the operating instructions.
Symbols
Warning of general danger.
Read the Operating Instructions/Notes!
Wear protective goggles.
Wear a dust mask!
Wear ear protection!
Safety class II
1 Intended use
As specifi ed, the machines are designed for sand-
ing wood, plastic, metal, composite materials,
paint/varnish, fi ller and similar materials.
With the SSH-LS130_B100 scraper (accessory), you
can scrape off fl oor and wall coverings, residual
glue, etc.
Materials containing asbestos must not be pro-
cessed.
Thanks to its linear sanding movement, the LS 130
EQ is ideally suited for sanding battens, straight
profi les and in rebates.
For reasons of electrical safety the machine must
not be damp nor operated in a humid environment.
The machine may only be used for dry sanding.
The user is liable for damage and injury
resulting from incorrect usage!
LS 130 EQ
260 W
4,000 - 6.,00 rpm
8,000 - 12,000 rpm
4.0 mm
80 x 130 mm
1.7 kg
2 Before starting up, please observe the
following
2.1 General Safety Rules
WARNING! Read all safety warnings, in-
structions, illustrations and specifi cations
provided with this power tool. Failure to follow
the warnings and instructions may result in electric
shock, fi re and/or serious injury.
Save all warnings and instructions for future
reference.
The term „power tool" in the warnings refers
to your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
2.2 Tool-specifi c safety rules
Always wear protective goggles because
of possible dangers when sanding.
- The manufacturer's handling and processing
instructions must be observed without fail if ex-
plosive or self-igniting dusts are likely to occur
during sanding.
- Harmful/toxic dusts can occur during your work
(e.g. lead-containing paint, some types of wood
and metal). Contact with these dusts, especially
inhaling them, can represent a hazard for operat-
ing personnel or persons in the vicinity. Comply
with the safety regulations that apply in your
country. Connect the electric power tool to a suit-
able extraction system.
To protect your health, wear a P2 protective
mask.
- Only for AS/NZS: The tool shall always be sup-
plied via residual current device with a rated
residual current of 30 mA or less.
2.3 Noise and vibration information
Typically, the noise levels that are determined in
accordance with EN 62841 (see EC declaration of
conformity) are as follows:
Sound-pressure level
Sound-power level
Measuring uncertainty allowance
Wear ear protection!
Vibration emission value a
directions) and uncertainty K measured in ac-
cordance with EN 62841 (see EU Declaration of
Conformity):
Vibration emission level
(3 directions)
80 dB(A)
91 dB(A)
K = 3 dB
(vector sum for three
h
a = 3.0 m/s
h
2
7