OVEN OPERATION TROUBLESHOOTING
PROBLEM
ERROR
Oven display does not
illuminate
Cooling fan continues to run
after oven is turned off
Oven is not heating
Oven is not cooking evenly
Oven light is not working
properly
Oven light stays on
Cannot remove lens cover on
light
Clock and Timer are not
working properly
Excessive moisture
POSSIBLE CAUSE
In the event of an error, the display flashes and beeps continuously. Dis-
connect appliance from the power supply and call a qualified technician.
Turn power off at the main power supply (fuse or breaker box). Turn power
back on. If condition persists, call an authorized service center.
Oven components have
The fan turns off automatically when the electronic components have
not cooled sufficiently
cooled sufficiently.
No power going to
Turn power on at the main power supply (fuse or circuit breaker box). If
oven
condition persists, call a qualified electrician.
Oven Mode or
Touch Functions pad to select the oven mode and temperature.
Temperature not
selected
Oven rack in incorrect
Refer to cook charts on pages 16–21 for recommended rack position.
position
Temperature not
Always reduce recipe temperature by 25°F (15°C) when baking with
converted for Convec-
Convection Bake mode.
tion Bake mode
Loose or defective light
Tighten the loose bulb or replace it if it is defective. Touching the bulb
bulb
with fingers may cause the bulb to burn out.
Oven door not closed
Check for obstruction in oven door. Check for a bent hinge.
completely
Dirty lens cover
There may be soil built up around the lens cover. Wipe lens cover area
with a clean dry towel prior to attempting to remove the lens cover.
No power going to
Turn power on at the main power supply (fuse or circuit breaker box). If
oven
condition persists, call an authorized service center.
Clock or Timer not set
See Clock Time and Timer on page 10.
correctly
Oven not properly
When using Bake Mode, preheat the oven first. Convection Bake and
preheated
Convection Roast will eliminate any moisture in oven.
SOLUTION
27
TROUBLESHOOTING
E