Sharp SWA2450GS Manuel D'utilisation page 11

TO TURN ON TOUCHPAD SOUND:
1 Turn the appliance off by touching the ON/OFF pad.
2 Touch and hold the – pad first, then the + pad for 2 seconds
simultaneously until a tone sounds. The touchpad sound is
now on.
SELECTING AN OVEN FUNCTION
1 Turn the oven on by touching the ON/OFF pad.
The symbol to the right indicates the oven is now
on and the function may be selected.
2 Touch the and pads to scroll through available cooking
modes and make selection.
3 The selected mode's default temperature
The oven will accept the default temperature after 5 seconds
if no modification is made.
4 Touch the – or + pads to decrease or increase the temperature
if desired.
The oven will begin preheating after temperature is selected.
Temperature may be adjusted once preheating has started by
using the – or + pads.
See Oven Modes section on pages 15–16 for more information
on available cooking modes.
CHANGING THE OVEN TEMPERATURE
The oven temperature is measured and displayed in degrees
Fahrenheit.
The cooking temperature may be changed before or during
preheating and cooking cycles.
Touch and hold the – and + pads to decrease or increase
temperature in increments of 25°F. Once new temperature is
selected, the display will momentarily turn off while temperature
is being adjusted and will illuminate again in 10 seconds with
new temperature displayed.
LIGHT
The oven light will remain on once an oven function has started.
The oven light will automatically turn off 10 minutes after the
end of a cooking cycle.
THERMOMETER SYMBOL
REGULAR PREHEAT:
During regular preheat, the thermometer
symbol will indicate the oven's heating
progress as the bottom segment illuminates
until the top segment is illuminated.
When all three segments are lit, the preheat-
ing cycle has completed. Place food inside of the oven.
Note: There is no audible tone signaling the end of the preheat-
ing cycle.
QUICK PREHEAT:
During Quick Preheat, the three segments
of the thermometer will flash in sequential
order. When the Quick Preheating cycle has
completed, the 3 segments will stop flashing
and remain lit.
QUICK PREHEAT
Quick Preheat can be used to reduce the amount of time the
oven needs to preheat by approximately 40%.
IMPORTANT: Do not place food inside of the oven until Quick
Preheat has completed and the oven countdown begins.
1 Turn the oven on by touching the ON/OFF pad.
will display.
2 Touch the
modes and make selection.
3 The selected mode's default temperature will display. The
oven will accept the default temperature after 5 seconds if
no modification is made.
4 Touch the – or + pads to decrease or increase the temperature
if desired.
5 Touch the Preheat pad to start Quick Preheat.
DELAY START
TO SET DELAY START
1 Select an oven function and touch the – or + pad to select a
temperature.
2 Touch the Clock/Timer pad and hold until the Cook Time
symbol
3 Touch the – or + pad to set the desired cooking time.
4 Touch the Clock/Timer pad again until the End Cooking
Time symbol
5 Touch the – or + pad to set the time the cooking sequence
should end.
6 The oven will be on standby until the calculated time is
met. The symbols for End Time
illuminate once the Delay Start has started.
7 When the time has elapsed, an audible signal will sound for
2 minutes.
Time
8 Touch any pad on the control panel to turn the audible signal
off.
Note: Once Delay Start is set, Cook Time cannot be adjusted.
To change Cook Time, cancel Delay Start by touching the ON/
OFF pad and reset.
11
CONTROL PANEL
and pads to scroll through available cooking
flashes.
flashes.
and Cook Time
0:00 is displayed and the End Time
symbols blink.
will
and Cook
E