Before First Use - Beurer MG 800 Mode D'emploi

Masquer les pouces Voir aussi pour MG 800:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4. Before First Use

Before using the Fascia Massager for the first time, charge it for at least 2½ hours as follows:
1. Connect the USB power cord to the AC Adapter and to the micro USB port on the end of the Fascia Mas-
sager (Figure 1). Plug the AC adapter into an electrical outlet. Alternatively, you can connect the power
cord to a USB port on your computer or laptop (Figure 2).
2. While charging, the Power Button flashes yellow. When the Fascia Massager is fully charged, the Power
Button will change to solid yellow. The device will operate for about 11 hours on a full charge. Charge the
Fascia Massager whenever the Power Button flashes red.
Figure 1
Preparing for Use:
You can use the device with or without plant-based massage oil. If you have thick body hair, using massage
oil will yield better results but we recommend using the device on smooth, hair-free skin whenever possi-
ble. Do not use any oils or creams with a strong cooling or heating effect, as they may cause skin irritation.
5. To Use
NOTICE
Only use plant-based oils as other oils may stain or damage the wooden finish.
Treatment without massage oil: (if you have little or no body hair)
A massage treatment without massage oil provides a surface massage, which activates the reflex zones
and treats the surface of the tissue.
Treatment with massage oil: (recommended if you have thick body hair or if you would like a
deep massage)
When using massage oils, the massage will penetrate deep into the tissue, increasing blood circulation
in the treatment area.
1. Put a couple of drops of plant-based oil in the palm of your hand.
2. Rub the plant-based oil evenly over the area you wish to massage. Before starting the massage treat-
ment, wipe your hands with a soft cloth to prevent them from slipping during the treatment and to pre-
vent damage to the silicone handles.
3. After treatment, wipe the wooden surface of the Fascia Massager and the treated body area with a
soft, clean cloth.
The amount of oil to be used depends on the effect you want. More oil causes faster vibration and therefore
a more intensive reflex action and blood circulation. Less oil causes a slower treatment that penetrates
deeper, with a very relaxing effect that loosens the tissue.
It is also possible to combine the two. To do so, apply a larger amount of oil onto the area to be treated
and move the Fascia Massager over the area quickly. Then wipe off some of the oil with a cloth and treat
the same area again, but this time with slower movements.
Figure 2
5

Publicité

Table des Matières
loading

Table des Matières