Publicité
CP Softener Series Owner's Manual
Central Brining System Installation
Use Teflon tape for all threaded pipe connections
For 39x60 (#4726A) and 50x60 (#4728A) Diameter Drums
1. Assemble bulkhead fittings to brine drum as shown, with the rubber washer on the inside. Be sure the washer does
not "squeeze" out while tightening.
2. Mount the brine well (Part #4758) to the drum using overflow fitting (Part #1138A) and nut (Part #1139A).
3. Assemble 90° elbow (Part # 3407) and nipple (Part #3406) to refill valve (Part #4967).
4. Install top collar (Part #2360) on bent float rod and position it 14 inches from straight end and secure. Slide ball on
rod. Position lower collar (Part #2360) on rod, and secure it approximately 2 inches from end of rod.
5. Screw "float to valve" adapter fitting (Part #3408) to float rod - DO NOT OVERTIGHTEN.
6. Using pin (Part #3411) and E-ring (Part #3413), attach rod and float assembly to valve (Part #4967) activator arm.
7. Lower float rod and valve assembly into brine well. Mount valve to tank through hole in brine well.
8. Assemble tube to nipple fitting (Part #4761) to nipple (Part #3406) through hole in brine wall.
9. Connect spray tube (Part #3431) to fitting (Part #4761) leading to valve and add end "plug" fitting to spray tube.
Plug fitting consists of (Part #4761) hose to female thread fitting and 1/4" pipe plug (Part #4762).
10. Using the 8 hangers (Part #3431), screws (Part #1869) and nuts (Part #3430) mount spray tube to drum using
holes provided. Spray holes should be angled down toward salt.
#3431
#1869
#3430
#4762
#4761
#1139A
#4758
#1138A
42
#3411
#3408
#4967
#3407
#3413
#2360
#3406
Publicité
