Publicité
KineticoPRO Softener Installation CP 208 - CP 216
I. Preparation
A. The following tools and materials are needed for installation: Phillips screwdriver, crescent wrench, pipe wrench,
pliers, pipe cutter, thread sealant / Teflon tape, ladder or step stool, drain line tubing and water softener salt.
B. Determine location to install equipment. Make sure that the unit will be on a flat surface. Test the water to confirm
unit is properly sized for installation. If sand/silt or turbidity is present, a separate pre-filter should be installed.
A ladder should be used for all work over head that would be beyond your natural reach. If working continuously
at a height of six feet or more, the appropriate safety devices must be employed.
II. Inspection
III. Turn off Water Supply
IV. Set Equipment in Place
Inspect all packaging for signs of damage. Examine the Tip-Tell indicator to ensure
that no one has tipped the system. If the indicator shows otherwise, refuse the
shipment. If the facility has already received the shipment, do not install the softener
as it will not function properly. In either case, contact your representative for
replacement equipment.
Before you begin, turn off the water that feeds the location where you'll be
conducting the installation.
Caution: water heaters and recirculation pumps may require isolation during
this process to prevent damage. Be sure to discuss with the site manager to
determine the best course of action.
A.
Set the equipment in place so you can determine the best plumbing orientation.
FOR MEDIA INSTALLATION: Remove module and remote bases from media tanks.
B.
•
Properly cover the distributor tubes to prevent media from getting inside.
•
For Model CP 210, place 14 lb or 0.15 ft
place 25 lb or 0.25 ft
0.75 ft
of gravel into each tank. No underbedding is used in Models CP 208.
3
•
For the Model CP 208, place 0.70 ft
should leave 15" of freeboard). For the Model CP 210, place 1.50 ft
capacity resin into each tank. (This should leave 15" of freeboard). For the Model CP
213, place 2.5 ft
(2 1/2 bags) of high capacity resin into each tank. (This should leave
3
14" of freeboard). For the Model CP 216, place 4.0 ft
into each tank leaving 18" of freeboard. Freeboard depths are estimates, and will
change with settling and the form of resin.
•
Remove covering from distributor tubes, and replace the module and remote bases
onto tanks.
Note: the CP 216 has an adapter with distributor that must first thread onto the tank before the module
is installed.
19
of gravel into each tank. For the Model CP 213,
3
of gravel into each tank. For the Model CP 216, place 75 lb or
3
of high capacity resin into each tank. (This
3
(1 1/2 bags) of high
3
(4 bags) of high capacity resin
3
Publicité
