Adjusting The Volume; Basic Operation - Teac CR-H101 Mode D'emploi

Turning the unit on/off (standby)
Press the STANDBY/ON (¤) button to turn the unit on. The indicator
lights blue when on.
Press the button again to put the unit in standby. The indicator becomes
unlit.
Changing the playback source
Turn the SOURCE knob to select the playback source.
The name of the selected playback source is shown.
Turn the SOURCE knob clockwise to change the playback source in the
following order.
USB Bluetooth
w
o If a digital audio format other than PCM is input, "No Signal"
will be shown and no sound will be output.
If this is the case, the connected digital audio output device
might have a "PCM" digital output format setting that would
enable playback. Refer to the operation manual for that device
to make this setting.
o To use this unit with a Windows computer, you must install
the dedicated driver on that computer before setting this unit
to USB and playing audio files on the computer (page 25).

Adjusting the volume

Turn the VOLUME knob or use the VOLUME buttons on the remote control
to adjust the volume to the appropriate level.
o The volume setting will be shown when you turn the VOLUME knob.
As the value increases, the volume becomes louder.
Display example
CD
VOLUME 15
Volume

Basic operation

LINE CD FM OPTICAL
w w w w
MIN: Minimum volume
MAX: Maximum volume
17