Error Messages - Domo DO9043W Mode D'emploi

DO9043W

ERROR MESSAGES

If you see "FINISHED" on the display: There is a break in the wiring.
If you see "SC" on the display: There is a short circuit.
In both cases switch the appliance off and remove the plug from the socket. Allow
onkly the manufacturer, its after sales service point personnel or an equally qualified
person to inspect the appliance in order to prevent accidents.
The baking trays do not rotate
If you fill the wafer iron after preheating and it expands too quickly or if you use self-
raising flour or yeast, the baking tray may turn slightly upwards. After 10 seconds
baking time the appliance will try to rotate the baking tray. As a result of the top
baking tray not closing properly, the axle will not be able to turn.
Pressing the baking tray down lightly by holding the insulated handles to close the
baking trays so that the appliance can rotate the baking trays is sufficient. Touch only
the insulated handles and not the baking trays, they can become very hot.
Acoustic Signal
If you have not done this within 1 minute, the appliance switches the motor off
automatically and you will hear the acoustic signal 4-times. Press the top baking tray
as described above by holding the insulated handles and pressing downwards until the
baking trays are closed and then press on START to begin the baking process again.
28