Publicité
If the red light emitting diodes glow
continuously / flash
A
B
C
D
A
1 light emitting
Battery is too
1) 2)
diode glows
hot
continuously
red:
B
4 light emitting
Malfunction in
diodes flash
battery
red:
C
3 light emitting
Power tool is too
diodes glow
hot – allow it to
continuously
cool down.
red:
D
3 light emitting
Malfunction in
diodes flash
power tool
red:
AR 900
All manuals and user guides at all-guides.com
1)
When charging: Charge process
starts automatically after the battery
has cooled down / warmed up.
2)
During operation: Power tool
switches itself off – allow battery to
cool down for a while.
3)
Electromagnetic interference or
fault. Acoustic signal can be heard
as a rapid series of beeps lasting
several seconds – see also
"Acoustic Signal". Disconnect
battery from power tool, take it off
your back, observe battery and
contact your STIHL servicing dealer
immediately – see also
"Troubleshooting".
4)
Electromagnetic interference or
fault. Take the adapter out of the
power tool and refit it. Switch on the
power tool – if the light emitting
diodes still flash, the power tool is
faulty and must be checked by a
STIHL servicing dealer.
1)
/cold
3)
4)
Light Emitting Diodes (LED)
on Charger
1
The light emitting diode (1) on charger
glows continuously green or flashes red.
Green continuous light ...
... indicates the following:
The battery
is being charged
–
is too hot and must cool down
–
before charging
See also "Light Emitting Diodes (LEDs)
on Battery".
The green light emitting diode on the
charger goes off as soon as the battery
is fully charged.
English
11
Publicité
