Placing the Paper into the Paper Cassette
1
A
Credit-Card Size
(Standard Paper/Full-sized Label)
B
Credit-Card Size (8-label Sticker)
• Please use specified paper types only.
• Be sure to fan the paper stack (so that the sheets won't stick together)
before loading the paper into the cassette.
• Do not insert more than 18 sheets in the paper cassette.
• Do not bend or tear off perforated edges on the paper prior to printing. Doing
so may cause the part of the ink sheet to be wasted. (The ink sheet is just
long enough to print to all of the paper in the ink/paper set. Wasting part of
the ink sheet will cause it to run out too soon.)
• Never print on a sheet of paper more than once, even if the first printing has
left the paper completely blank. The coating applied to the paper as it passes
through the printer makes it unsuitable for further use. Reused paper may
stick to the ink sheet, resulting in damage to the printer.
• Please also refer to "Proper Usage and Handling" for advice about proper
paper handling. (
Top Cover
Middle Cover
Paper
(Glossy side up)
p. 12)
Place the paper into the paper
cassette, with the printable side
(glossy side) facing up.
• To open the paper cassette: Open the
top cover, then push the middle cover
in the direction of the arrow and lift it
up.
• Insert the postcard size paper with the
glossy side up and the address/stamp
side last.
• After loading the paper, push the
middle cover back toward its original
position until it clicks into place. But
leave the top cover open.
• Insert the credit-card size (standard
paper/full-sized label) as shown in
figure A.
• Insert the credit-card size (8-label
sticker) as shown in figure B.
19